Domestic soybean milk machine maintenance method

Soy milk nutrition is good, it is tonic in the winter to share. The popularity of soymilk makers also allows people to enjoy a cup of homemade soy milk at any time without worrying about preservatives and hygiene issues. But do you also pay attention to the maintenance of the soymilk machine when you taste the delicious homemade soymilk? Here's a few tips for everyone to introduce the maintenance of soymilk.

1. After the pulping is completed, especially after cooling the whole nutrient soymilk and mung bean soy milk, please do not reheat and beat it again, otherwise it will cause sticking.

2. After the machine is working late, after the work is completed and during work, please do not pull out or plug in the power cord and press the button again to execute the work program. Otherwise it may cause heater paste, soy milk overflow or long alarm.

3. During the production of soy milk, the water or water level in the cup is too low, the machine is in self-protection or alarm state, the motor and heating pipe are not working, and it is not a fault. The amount of water placed close to the upper water line is better.

4. When the machine is working, please do not forget to install Rafal net, otherwise the machine will overflow during the process of beating so as not to scald.

5. When the machine is working, keep a certain distance from the socket, so that the plug is in reach and away from flammable and explosive materials, and the grounding wire of the power socket must be well grounded.

6. Soymilk should be placed horizontally on the platform so as to prevent the machine from vibrating or tilting due to tilting.

7. To avoid accidents, please follow the specification specification.

8. After the heat is applied, the net cover and the under cover of the head cover are over tightened. When the net cover is disassembled, it should be cooled with cold water to avoid scratching the hand or damaging the net cover.

9. When the soya-bean milk machine is not in use, please keep it clean and put it in a ventilated and dry place. Water, moisture, mildew and other factors can easily cause the motor to burn out, and sunlight can easily cause the plastic to fade.

10. When cleaning the nose part, be careful not to immerse the entire head in water. This will damage the body and cause a dangerous short circuit. You may use a running water or a cleaning brush to clean the head part.

11. Drinking water in some areas can cause soymilk to condense into a bean curd-like condition. The main reason is that the water contains too much minerals. You can use cold water or add a small amount of salt to the water.

12. When washing, only use water, cleaning brush to wash the soymilk stuck in the lower part of the head, do not soak the head into the water or water to wash the upper part of the head, the upper part of the head and the power outlet part, and it is forbidden to enter the water.

13. After use, the plug must be unplugged from the socket before cleaning to avoid the risk of electric shock. When the surface of the housing is dirty, wipe it off with a soft cloth; when it is seriously dirty, wash it with a detergent.

14. To clean the barrel, turn it clockwise to remove it, remove the slurry separator, drain the pulp from the pulp, and gently wash the surface of the milk fiber with clean water and a brush.

15. If scaling occurs on the electric heater inside the drum, brush it with a brush; if it cannot be brushed off, use cold water for a while before cleaning. Then, drain the remaining water from the cleaned drum. Wash it with a little water and drain it. It is also possible to remove the surface layer of the electric heater by boiling water.