The fourth member meeting of the Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry was successfully held

The fourth member meeting of the Semiconductor Lighting Technology Standards Working Group was held in Shenzhen. Han Jun, deputy director of the Department of Science and Technology, Ding Wenwu, deputy director of the Electronic Information Product Management Department and the head of the semiconductor lighting technology standards working group, attended the meeting and delivered a speech. Deputy Director of the Institute of Electronic Standardization Zhang Hongtu, Deputy Secretary-General of China Electronics Standardization Technology Association Pang Chunlin, 38 representatives of 29 member units of the Semiconductor Lighting Technology Standards Working Group (hereinafter referred to as the Working Group), and the Science and Technology Department and Product Division of the Ministry of Information Industry, Relevant personnel from the Institute of Electronic Standardization and the China Light and Power Standards Association attended the meeting.
Deputy Director Han Jun proposed to firmly establish the purpose and concept of service for industrial development in the process of standard research and development, to promote independent innovation, to integrate with industrial policy and industrial development; to grasp the field according to current industry development trends Standardized research is required to accelerate the development of semiconductor lighting technology standards. Deputy Director Ding Wenwu clarified the work content and requirements of this meeting, reviewed and affirmed the work done by the working group for more than two years, and hoped that everyone would do their due diligence and do a good job in the preparation of relevant standards to promote industrial development; On the basis of extensive solicitation of comments on standard texts, trials are submitted as soon as possible for relatively mature standards. All member units are required to use the powers conferred in accordance with the requirements of the working group's articles of association, perform their prescribed duties, and assume corresponding obligations.

After careful discussion, the meeting agreed that the seven semiconductor lighting technology electronics industry standards could be submitted for review. The meeting also studied the work in 2008. The working group will convene a working group meeting in April 2008 to identify new work items and commitment units.

The Standards for Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry

According to Xinke Han [2007] No. 21 “Notice on the release of the first batch of electronic industry standard research plans for 2007”, the Semiconductor Lighting Technical Standards Working Group is responsible for the formulation of the following standards:
Project number project name

S07006-T

Semiconductor lighting terms and definitions

S07007-T

Semiconductor optoelectronic device small power LED blank detail specification

S07008-T

Phosphor for semiconductor light-emitting diode

S07009-T

Semiconductor light emitting diode chip test method

S070010-T

Sapphire substrate for gallium nitride based light emitting diode

S070011-T

Semiconductor light-emitting diode product series spectrum

S070012-T

Power semiconductor light-emitting diode chip specification

2008 Recommended Standards Project of the Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry

——Characterization and testing method of “thermal characteristics” of chip——Test method of “quantum efficiency” of phosphor——LED light radiation test method——LED accelerated life test method——LED module test method——LED energy efficiency——small Dimensional LED backlight - medium size LED backlight - LED control, drive circuit - epitaxial wafer test method - low power chip specification - LED flash for photography - LED light source for photography - LED model nomenclature

Iphone Lightning Cable with Lightning Connector Sync and charge your iPhone, iPad, or iPod with faster speed.

The Iphone Charger Cable could meets your need for any place . Its length contains 3tf , 6ft , 10ft , etc .

Our customers and the media all agree on one thing: this cable is one of the best iPhone Lightning cables in the world.

This iPhone charger cable boasts increased durability, faster charging, faster data transfer and compatibility with almost all cases. Give your iPhone the treatment it deserves.

iPhone Lightning Cable compatible with IOS devices that have a Lightning port, including iPhone 8 /7 / 6 / 6s,iPhone 8 Plus / 7 Plus / 6 Plus / 6s Plus, iPhone 5 / 5C / 5S,  iPad with Retina display, For iPad mini,  iPad Air,  iPad Pro, iPod nano 7th Gen and  iPod touch 6th Generation.

The iPhone charger cable which with Original 8 Pin connector with a lightning end has lightning-fast data transfer , retro comfortable, soft and elastic,strong, durable ,dirt , no deformation.

We are committed to providing  professional, safe and stable mobile powers for our customers .

Iphone Lightning Cable

Iphone Lightning Cable,Iphone Charger Cable,Iphone 6 Charger Cable,Long Iphone Lightning Cable,Apple Iphone Charger Cable,Iphone Usb Cable

Hebei Baisiwei Import&Export Trade Co., LTD. , http://www.charger-cable.com